Fastener replacement
Backed out fasteners are swapped to close leaks at every screw.
A roofer in Denville can repair a mobile home roof by resealing open seams, replacing loose fasteners, sealing vents and the AC curb and recoating the roof so it sheds water again. Call (862) 421-0116 to reach a local roofer for mobile home roof repair.
A mobile home roof has its own weak points, and most leaks start at the same few spots. The roof might be metal panels, an EPDM or TPO membrane, or asphalt shingles on a pitched roof, depending on the age and model of the home. For metal roofs, panel seams, fastener holes and dried sealant at vents and the perimeter edge cause most leaks.
Water does damage quickly in a manufactured home. Thin ceiling panels stain and bow, insulation gets soaked and the wood framing can start to rot before the leak is obvious. If a ceiling panel bulges with trapped water, a small hole at the low point lets it drain into a bucket, keeping clear of light fixtures, and power to that area should be shut off at the panel if it is safe to reach.
The framing under a mobile home roof is light, so walking it takes care. Stepping between the supports can buckle the metal or damage the ceiling, so roofers stay on the truss lines. Never go up when the roof is wet or icy, and check the data plate inside the home, which lists the roof load zone the home was built for.
Depending on what the roofer finds, mobile home roof repair in Denville, NJ can go hand in hand with roof coating and metal roof repair.
Dealing with this in Denville, NJ right now? Call (862) 421-0116 and describe the problem to a roofer who works in Denville.
Call nowA lasting repair seals the roof and deals with any water damage underneath.
Every seam, screw, vent and edge is checked, along with low spots where water sits. Inside, ceiling stains help point to where water is getting in.
Missing or loose screws are replaced and panels are secured so the roof stops rumbling. Surface rust is wire brushed and primed.
Panel seams are cleaned and sealed with butyl seam tape or a reinforced seam sealer. On rubber roofs, the roofer patches with matching membrane and lap sealant.
Old caulk is removed from vents, skylights and the AC curb, and they are resealed with a sealant compatible with the roof, or replaced if cracked. The edge rail around the roof is resealed too.
A reflective coating over the whole roof ties the repairs together and slows rust. Coatings need dry weather and a clean surface to bond.
Backed out fasteners are swapped to close leaks at every screw.
Rotted sheathing or framing under leaks is repaired where water sat the longest.
Cracked vent caps are replaced with a sealant that suits the roof.
An elastomeric or silicone coating is applied which slows rust on metal.
Seams on metal and rubber roofs are repaired to stop drips into the ceiling.
When repairs cannot keep up, a mobile home roof replacement removes the old roofing and installs a new system. Older metal roofs are often fastened directly over the trusses with insulation below, so replacement can include adding a deck, more insulation and a new membrane or metal roof. Rotted trusses are repaired or reinforced before the new roof goes on.
In Denville, mobile home roof replacement plans begin with the data plate and the condition of the trusses. Ask whether a permit is needed, since manufactured homes can have their own rules. Done right, the new roof should end the cycle of patching.
A mobile home roof over installs a new roof on top of the existing one instead of tearing it off. Options include a framed pitched roof that adds an attic space, an insulated membrane roof over, or new metal fastened over furring strips. Many roof overs add insulation, cutting heat gain and making the home quieter in storms.
Before a roof over on a Denville mobile home, the added load and the way the new roof ties into the walls have to be worked out. Pitched roof overs in particular may need engineering and a permit, and they should be anchored to resist wind uplift. A good roof over ends the seam and screw leaks that plague old metal roofs.
Around Denville, mobile home roofs include older metal roofs, rubber membrane roofs and newer shingle roofs on pitched manufactured homes. For homes in Denville and nearby towns like Rockaway, Mountain Lakes, Morris Plains and Dover, resealing and recoating every several years keeps most metal roofs dry, and storms with strong wind are what loosen fasteners and lift edges.
For mobile home roof repair in Denville, NJ or nearby towns like Rockaway, Mountain Lakes, Morris Plains and Dover, call (862) 421-0116 to reach a roofer who covers your street.
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Denville is busiest after a hard winter and before the next one.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Local roofers see the same roofs and storm damage across Denville and nearby towns.
Ask your questions before you agree to anything.
More questions? Call (862) 421-0116
Silicone, acrylic and other liquid coatings that renew aging flat, low-slope and metal roofs, after the seams and blisters are repaired.
Learn moreMetal roof repairs that stop leaks at the screws, laps and flashing, so the panels keep shedding water for years more.
Learn moreRepairs for leaking rubber roofs, from peeling seams to pulled flashing at walls and curbs, after the real leak point is found.
Learn moreFinding where water gets through the roof and sealing it at the source, with the damage underneath checked too.
Learn moreLooking for something else?
See all roofing servicesCall now for Denville mobile home roof repair and help in the towns around it.